RPM Calibration - Altrac Wind Machine Station (ST100)

For instructions, view the video below:

RPM Custom Calibration 

How to Adjusting the Speed multiplier? 

     Adjust Speed Multiplier until it matches actual RPM on wind machine panel.

How to Set a Custom RPM Calibration? 

     To set a custom RPM calibration, run your Wind Machine through a full run cycle that includes engine off, warm up, full run and cool down. Set "Warm Up Value" below to a number 10-20% below the engines warm up speed. Set "Full Run Value" below to a number between warm up speed and full run speed. When this is done correctly, the red line for warm up value will appear between engine off and warm up speed and the red line for full run value will appear between warm up speed and full run speed.

After updating the firmware on an ST100 it is critical to resave any default or Custom RPM calibration on the Altrac application.