
Neil Schultz
- Total activity 167
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 118
Articles
Recent activity by Neil Schultz-
Installation Instructions: Electrician
Overview In order for Altrac's Pump Station to control pump equipment, you will need to install the Pump Buddy and make connections between the Pump Buddy and the VFD or Contactor Setups. The goal ...
-
Installation Instructions for WH131: Orchard Rite CAN Retrofit Harness
Make: Orchard Rite Engine: V-10, CAT 4.4, CAT 6.6/7.1, Ford 6.2L V-8 Autostart: Orchard Rite Altrac Wiring Harness: WH131 The Orchard Rite CAN retrofit harness adds the capability to communicate di...
-
Flow Meter Instruction Manuals
Seametrics AG3000 User Manual
-
Flow Meter FAQs
Does your Flow Meter Station work with any flow meter? Our flow meter station works with any flow meter with a pulse or current output. This usually is a digital flow meter with a wire pigtail. If ...
-
Installation Instructions for WH123: Vamco Ford 6.8L V8, Dynagen 600 Series
Manufacturer: Vamco Engine: Ford 6.8L, V8 Autostart: Dynagen ToughSeries Pro TE600 Altrac Wiring Harness: WH123 Step 1: Ground Black Wire -> Engine Battery Ground Attached the black wire from th...
-
Alert Setup
Alerts are text messages, phone calls, or emails sent to a user to notify them of a sensor value reached or a machine state. These are setup through the webapp. FAQs: How do I set up an alert...
-
User Manual
ST140 Table of Contents Specifications Consumer Safety Information Description of Operation Installation Models Operating Instructions - Web App Operating Instructions - Physical Button Error Code...
-
RPM Calibration - Altrac Wind Machine Station (ST100)
For instructions, view the video below: RPM Custom Calibration How to Adjusting the Speed multiplier? Adjust Speed Multiplier until it matches actual RPM on wind machine panel. How to Set ...
-
ST100 User Manual
Table of Contents ST100 Key Components Device and Tile States Overview Tile Controller State Machine State RPM Air Temperature Battery Voltage Fuel level Banners Specifications Cell...
-
Finaling a Wind Machine Install
Orchard Rite Setup Verify Altrac is sending correct temperature to auto start: Orchard-Rite autostart display should read 90F when Altrac device is sending stop signal Orchard-Rite autostart disp...