Neil Schultz
- Total activity 168
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 119
Activity overview
Latest activity by Neil Schultz-
Neil Schultz created an article,
Flow Meter Instruction Manuals
Seametrics AG3000 User Manual
-
Neil Schultz created an article,
Installation Instructions for WH131: Orchard Rite CAN Retrofit Harness
Make: Orchard Rite Engine: V-10, CAT 4.4, CAT 6.6/7.1, Ford 6.2L V-8 Autostart: Orchard Rite Altrac Wiring Harness: WH131 The Orchard Rite CAN retrofit harness adds the capability to communicate di...
-
Neil Schultz created an article,
Installation Instructions: Electrician
Overview In order for Altrac's Pump Station to control pump equipment, you will need to install the Pump Buddy and make connections between the Pump Buddy and the VFD or Contactor Setups. The goal ...
-
Neil Schultz created an article,
-
Neil Schultz created an article,
Custom RPM Calibration
WARNING: Customizing engine calibration should only be done in rare cases where you've installed an Altrac device on a non-standard engine. The default calibrations are sufficient for 98% of all Wi...
-
Neil Schultz created an article,
-
Neil Schultz created an article,
Installation Instructions for WH123: Vamco Ford 6.2L V8, Dynagen 600 Series
Manufacturer: Vamco Engine: Ford 6.2L, V8 Autostart: Dynagen ToughSeries Pro TE600 Altrac Wiring Harness: WH123 Step 1: Ground Black Wire -> Engine Battery Ground Attached the black wire from th...
-
Neil Schultz created an article,
RPM Calibration - Altrac Wind Machine Station (ST100)
For instructions, view the video below: RPM Custom Calibration How to Adjusting the Speed multiplier? Adjust Speed Multiplier until it matches actual RPM on wind machine panel. How to Set ...
-
Neil Schultz created an article,
Deutsch/Amphenol Connectors and Crimping
Altrac uses 12, 6, and 3 pin Deutsch/Amphenol connectors. You'll find these on many of our harnesses, especially in the wind machine product segment. Connectors Crimping Tool Setup Contact ...
-
Neil Schultz created an article,
User Manual
This document gives step by step instructions on how to install your Altrac MultiStation (ST160/161) for valve control and pressure monitoring. Tools and Materials Size Use Phillips Screwdr...