Altrac LPG-Propane Fuel Sensor (SN110)
-
Hall Effect Sensor (Plugs into dial on tank)
-
6-Pin Deutsch Connector (plugs into Accessory Port on Altrac wiring harness)
-
Intrinsically Safe Barrier Device
Specification |
|
Length | 40' (12m) |
Max Length (with Extension) | 500' (150m) |
Min Propane Level | Inaccurate below 20% |
Max Propane Level | Inaccurate above 80% |
Accuracy | ±10% |
Sheath | Nylon sheath for rodent protection |
Calibration | Pre-calibrated. No need to calibrate |
Extension Cables (SN110_EXT_X)
Altrac offers extension cables for the SN110. Each extension comes with two connectors in order to create an easy, waterproof connection. Contact sales@altrac.io for more information.
Power Requirements:
12VDC. The wind machine battery must be connected for the fuel sensor to function properly.
Maximum Range:
500 ft (150m)
Accuracy:
The propane fuel sensor is accurate to +-10% when the dial is reading between 20-80%. We cannot guarantee accuracy when dial is below 20% or above 80%.
Webapp Tiles:
Normally you will see percentage full of your tank:
If the probe is disconnected you will see:
If the probe is connected but giving a value outside of its range, you will see:
Cost of Extension Cable:
$.60/ft + $40 for connectors and labor. Cable is rated for direct burial. Connectors are removable if you want to pull the wire through conduit for added protection.
Known Issues:
While the wind machine is running, the propane level will not update. This is a firmware issue that will be resolved in a future release. 1-5-2022. See below for an example.
Comments
0 comments
Please sign in to leave a comment.